Those little headlight scoops?
#1
If I have a spare fc laying around, which includes headlight panels (or whatever you call them), is it feasible to cut a hole in the right headlight panel and use bondo to create a fresh air inlet scoop? Or will I end up with a piece of **** to add to the pile?
#3
this may sound stupid...but what should I cut with if I'm not going from the edge? I was planning on just cutting 3 sides of the space and just bend the piece down, then bondo. sound good?
#6
It would be for looks anyhow, those little scoops serve no purpose.
If you want to try it though go ahead, but not like you can mold bondo like clay and expect it to stay like that, it will probably end up cracking or just falling off.
If you want to try it though go ahead, but not like you can mold bondo like clay and expect it to stay like that, it will probably end up cracking or just falling off.
Thread
Thread Starter
Forum
Replies
Last Post
phinsup
Insert BS here
0
07-04-2006 08:13 PM
Cheers!
2nd Generation Specific
3
05-10-2006 04:29 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)