[quote name='gentlejax2' date='Apr 7 2005, 10:37 AM']OK, there are 7 different part numbers for all types of things. what all do I need to get...?
o rings grommets air bleeds ... [snapback]696512[/snapback] [/quote] i found a kit from borg warner at oreilly here. you can probably find this anywhere. the kit has all the stuff to do all injectors and it only like 7 bucks. just make sure they order you the right one bc they didnt for me and it sucked |
A good injector shop will supply the O-rings & insulators.
I keep a few spares in case one leaks. Make sure the fuel rail pocket has no stuck on bits of the old O-ring. Put a dab of oil on the O-ring when you insert the injector so you don't scratch the new seal. |
[quote name='sureshot' date='Apr 7 2005, 11:09 AM']
Put a dab of oil on the O-ring when you insert the injector so you don't scratch the new seal. [snapback]696542[/snapback] [/quote] fsm says to use gas to lube it |
Holy sheet! my local Mazda dealer wanted to charge me almost $200 for the "air Bleed" things that I may or may not need.....parts guy didnt know either.
anyhow, I skipped them and just ordered the UIM gasket. My injectors came with new O'rings, filters, and pintles. I think that is the correct name for the stuff. they are complete and ready to go. what I needed to know about was any of the other stuff I might need like the UIM gasket. thanks and wish me luck! Mike |
All times are GMT -5. The time now is 04:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands