vboy714

hi guys.. i know im new but i am in need of desperate help.. i swapped in a S5 T2 motor in my S5. my problem is that it will not start. i installed a new walbro fuel pump.. i have spark on all four plugs. i pulled the plugs out and cranked the engine.. no smell and dry as hell. so im assuming that my injectors are not firing.. any suggestions on what to look for.. any help is greatly appreciated.. thanks

Medicj02

pull a fuel line and check (there are 2, one to the engine from the pump and a return)....if you have fuel in either line then your pump should be working, if not then check the wiring on the fuel pump......next thing to do if you have fuel in your lines would be to make sure the lines are hooked up right.....then if it still doesn't start then check the injectors and make sure they are clean.....you can use an air compressor to try to blow air through them.



Well....let us know if that helps.

vboy714

thanks for the help.. fuel lines are hooked up correctly and fuel is going through... the problem is that my injectors wont fire.. i noticed with the key in the on position i do not here the fuel pump.. when i jump the fuel connector is stays on constantly.. either way fuel is still pumping through.. is this normal? thanks

Medicj02

pull out your injectors and check to make sure they're not clogged up.

anhcore

hey vboy714! i'm having the same problem! when you figure it out let me know man! good luck to you!