j9fd3s

my 02E would be to move the staging bar away from boost, it helps with the transition for some reason



mike

turborotor

The problem now is not the transition. I can't tell if its going lean or misfiring due to a bad cas or a break in the wiring to an injector or from the cas or power to the ecu.



This happenned before a year ago and I fixed it. But i dont' think i distrurbed that wire again. Will check them all out tommorow.



I do have a plug going to the fuel injectors. Going to cut it off and soldering together directly.



C

j9fd3s

well, you could do a datalog run until you get the symptom, it should show up there?



mike

turborotor

i'm 99.9% sure what the problem is. I most of disturbed or pinch the wire the haltech uses for switch power. I did that last yeah and put a fresh wire and good splice. I guess not. I wiggle the wire and the engine will stuble on idle. I'm goign to take a break and dig the wire and hopefully do a better job than last yeah.



I have the switched power coming form the leading coil. I did pull on the IC pipe hard up so it must of pinched it. Same crap from last year V.



C