can somebody tell me hoy to make a crossmember

 

pieces of metal, drill, welder, some bolts, etc.



kevin.

 

LOL at Teknics ! ! ! !



It takes alot of patience to do a motor swap where already made mounts are not available, Unless you live in movie land and can make a skyline motor fit in a old mustang overnight. And I dont want to be a ***** or anything but if you cant figureout how to fabricate mounts/crossmember i dont want to question what you will be using for engine managment or custom drive shaft or many of the other one off parts that need to be fabricated when doing uncommon engine swaps.

 

If you were putting it in a british car, i would say you can run down to your local lumber liquidators and pick up some 2x4s, some nails, a hammer and your good to go.

 

LOL being good at fabrication is a great thing. I love fabbing stuff for my cars.



Kevin.