I know how much of a pain that **** is cuz I had to remove that **** at the junkyard once, I imagine it must be even worse when you are trying not to break anything important..

but does anyone know what to remove on an 86 n/a? I've got it all apart, and want to take full advantage of the situation





and is there some kind of sealant I'm supposed to use with the intake manifold gaskets?

Use Hylomar. I Look at my TII Harness thread.

It seems that it'll only be worth it if I had a tII. I'll just leave all that stuff in there, cancelling the risk of me messing up anything.

I don't know about that, if you don't have to pass emissions tests I'd say get rid of it and eliminate all the bullshit.

it's just that all that topic on the other forum was for the turbo, and I'm not sure if I can make the translation

well I did it on mine when I installed my new engine, it's pretty straight forward.



You just remove the ac&cv (blockoff plate) remove the rats nest, get some fuel line and run it directly to the fuel rails for the feed/return lines... After that you just cap all the vacuum lines except the one that goes from the LIM to the dynamic chamber (the one for the injectors at idle), connect the FPR directly to one on the dynamic chamber, and you leave the boost sensor connected to the UIM on the stock nipple... everything else, capped.



I eliminated my stock oil injection so i'm not sure if you have to do something to handle that if you keep it, I don't recall how exactly the oil injection works, I think it gets vacuum possibly, it would be easy to find out by looking at a diagram.



my car is running fine now, and theres none of that junk.. I have yet to hack up the harness and remove the connectors/wiring related to the emissions solenoids that have been removed, but that can be done at any point.