question about the TB mod
#1
please dont link me to FC3Spro.org or something, i have an 86 N/A and the sites ive seen only support this mod for the TII's, my TB is different than the ones showing in those pages, can somebody direct me elsewhere?
TIA,
Leo
TIA,
Leo
#6
I used the directions there for both my cars. The stuff you are removing is pretty much the same. The butterfly that you are removing is the first pair that are alone (looking in the direction the air would flow).
#8
yes. It should look something like this after you remove it:
http://pengaru.com/~swivel/cars/rx-7/10-22...02/IMG_1792.JPG
note the holes left behind, thats where the shaft WAS which you are removing. This throttle body has also undergone some porting but is unfinished in the picture... and has yet to visit the welder to get the holes filled.
http://pengaru.com/~swivel/cars/rx-7/10-22...02/IMG_1792.JPG
note the holes left behind, thats where the shaft WAS which you are removing. This throttle body has also undergone some porting but is unfinished in the picture... and has yet to visit the welder to get the holes filled.
#10
Yes, you can put a plug in the hole where the shaft was, or use JB weld. Have you gone to FC3spro, and read the instructions? Alot of the questions you have are answered in the step by step provided there. Go through and read all the steps while you have your TB in your hand, then come and ask any questions.
http://fc3s-pro.com/TECH/HOWTO/TBM/tbm.html
http://fc3s-pro.com/TECH/HOWTO/TBM/tbm.html