I put in a little less than 16 ounces of Xcel 2 stroke in the tank It says that it is good for injection and pre-mixing Is this stuff any good or should I use some other brand?
|
all you need is a tcw3 oil
|
what is tcw3?
|
thats the rating of the oil.. you will see it on the quart somewhere.. usually on the front....
|
im not sure if it is since the bottel is in the car and im up stairs but what if it is not?
|
tcw3 is safe for fuel injection. I use premix of 1 oz per gallon of gas. I have my OMP diabled, actually used block off plates and plug the injector lines.
|
thats the same thing i did. i use either valvoline or the wal-mart 5gal jug for $5. i use about 16 oz. per tank, unless i know i will be driving "spotry"https://www.nopistons.com/forums/pub...#>/BURNOUT.gif then its a little more. basically a 1oz. per gallon is a 100:1 ratio. most weed eaters use a 50:1 ratio. its a pittle ritcher.
ej |
https://www.nopistons.com/forums/pub...IR#>/blink.png Did you put regular 2 stroke in there????
|
Damn!! You guys are mixing in a lot of oil. What ratio are you shooting for 60:1?? I was instructed by pettit racing to mix 4oz per tankful of their Protek premix. 6oz when I am racing.
When I used Amsoil premix I did the same. When I tried to run 8oz per tankful I was fouling plugs and my car was breaking up real bad at high RPM's. |
16oz its a lot!, like jim said 4/6 oz its ok for me
what ratio most people use? |
All times are GMT -5. The time now is 08:48 PM. |
© 2024 MH Sub I, LLC dba Internet Brands