pic request... mounted single exhaust passenger side
#2
I did mine passengers side using 3.5 inch dia piping and 2 mufflers. a borla XR-1 oval under car and a magnaflow race round muffler with a turn down. its a tight fit but ill try and get some pics soon. check out my vids to see how it sounds and there is a couple of desent tail shots in it too. pm me a email addy to send some real pics though
#4
i used stock hanger locations , just bent up .375 rod and welded it onto the exhaust when i had the exhaust in its proper location with a little extra push up on the exhaust so when the jack stands or however your holding up the exhaust to weld are gone the stock rubber hangers will have slight tention on them to hold them in place and give the proper cussion.
Thread
Thread Starter
Forum
Replies
Last Post
RX-187
Interior, Exterior, Audio Mods
17
04-04-2003 08:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)