I read through the topic in 1g specific and I have a couple of questions.
I'm going to install the blockoff plate, weld the LIM holes and I guess put bolts in the block. Do I have to do anything with the omp drive gear since I'll have the front cover off anyway? What size bolts do I use on the block and do I have to tap the holes first? I'm worried about shavings getting into the engine. Chris |
for the bolts just get the same thread as the omp injectors.
you can take the drive gear out, but i think if you do that you need to plug another passage mike |
Thread size 10 x 1.25mm
|
|
I found the right bolts (10x1.25mm) and tested them in the LIM holes, with a lock washer, they should be about 5/8 inch long.
How long do the bolts have to be for the injectors on the engine? Are they the same length? |
the engine ones are a tit bit shorter
mike |
Here's a handy trick: Put a nut on the bolt BEFORE cuttting off the excess thread
|
and dont cut your nuts
mike |
Originally Posted by j9fd3s' date='Apr 22 2003, 12:41 PM
and dont cut your nuts
mike |
All times are GMT -5. The time now is 06:31 PM. |
© 2024 MH Sub I, LLC dba Internet Brands