i broke the plastic lines that go from the OMP to the oil injectors and i was wondering what will happen if i dont install the OMP and run premix. also can i use rubber lines to replace the plastic lines or is there a reason the rubber lines wont hold up
|
S4 or S5? I believe the OMP talks to the ECU in the S5 and it will put you into limp mode or something.
Ah, heck. That's probably a load of crap. I do know that the S5 pump is controlled by the ECU, while the S4 uses a mechanical linkage tied to the throttle. |
S4 no problem, just block off the OMP, if you remove it from an S5 it will go into limp mode.
Depends on the rubber, a lot will just get destroyed by the oil. I had good luck using fuel line for an RC car, I will have to say that the SS braided lines that scalliwag made a while ago are the best!! |
you wont have any problems with a short piece of hose on there. the oil will eat rubber, but not today, more like 2-3 years from now. silicon works, the RC car fuel line is probably the best solution.
braided sucks, when it saws thru the intake manifold or fuel injector, you'll agree |
I'm looking for an omp block off plate. Where can I find one ? I checked mazda trix and racing beat. If they have them can you give me a part # or what section to look under.
thanks Dave |
|
thanks I have made some of my own block off plates and they don't look so good.
Dave |
are you getting an rtek to go in your ecu?
|
If that Rtec question was for me I'm running a HALTECH
Dave |
Yes it was lol. Just making sure, didnt want to have you block it off and go into limp mode.
|
All times are GMT -5. The time now is 02:57 AM. |
© 2024 MH Sub I, LLC dba Internet Brands