RicerJ

ok so last week i lost my turn signals on the way home after a meet i had them all day and driving there then on the way home i realized i lost them when i didnt see it show up i hear it but its not showing up is there a relay to check? or what could have caused this id like to get my turn signals back and no fuses are blown

RicerJ

so today i rechecked my fuses and i found my hazards one blown so i replaced it with a good 10 amp one and it it blows the second i turn it to on and also i forgot to say but its stated in my sig and on the side but its a s4 na

rtrypwr98

Sounds like a short to ground issue. pinched wire, no insulation, etc. There should be a little metal box that is what makes the blinker flash, breaking and engagin the connection. Have fun tracing wires

RicerJ

metal box?? i know the black box is by the kick panel but whats this metal box

rtrypwr98

I'm not sure if these have the same thing but most cars have a small tin box that is a flasher that plugs in. Something that breaks and reconnects to make the blinkers blink. I will check a manual and see what it has. but if your blowing fuses something is shorted. I will check the manual tomorrow and see what those wires run through. Probably gonna have to trace it. and hope it's not the turn signal switch.

RicerJ

its fixed now i replaced the black box which houses the turn signal cpu and went through the harness to find 2 pinched wires by the seat belt bolt which i taped and laid it back in and everything works now no blown fuses and i have turn signals and hazards again

rtrypwr98

NICE. So the turnsignals have a CPU. how pricy was that? Awsome you found the pinch

RicerJ

a buddy of mine took one from a junkyard and it worked fine