havent had to go this far myself, but i think it wouldnt be too hard to trigger the coils by yourself, at least youd know if the coil->wire-> plugs worked or not

 

alllrighty firmware reloaded, no dice.

checked the ignition setting after the reload they were fine.



so does any one know how much voltage the coils take to be triggered?

5v?

 

I forget which wires it is but there is a signal wire that takes a 12v signal.



IIRC: On the leading coil, it fires both plugs everytime that wire sees 12v. On the trailing coil, it fires one plug when the wire gets voltage, and the other plug when the wire loses voltage.



I'll double check that later.

 

cool so i just supply 12v to the power then tap another 12v to the signal and i should get one spark correct? when using the leading pack.

 

Try changing the plugs and wires, you would be amazed of what that does. Also change the blinker fluid while you're at it.

 

yea and ill replace the muffler bearings to... ***

any way i got it figured out.

 

hahaha, it was the plugs huh?

 

yeah yeah yeah... but i had replaced them allready so unless you can explain the freak occurance of brand new plugs being bad... i dunno what ever... it was annoying im just glad its fixed. you can now commence giving me ****...

 

nah im cool, just dont talk **** about other peoples cars at walmart. hahaha

 

lol i only tell the truth! just cause mines faster dont mean you need to get mad