Rotaryman88

Well, to my surprise..FedEx not only found my house, but found it on a Saturday! Here are some pics of the exhaust(cat back for se-x)...compliments of Revvin7. Minus a small ding on one muffler, hardly noticeable, it looks good...although revvin7, I wouldn't use that exhaust shop again...they have some ugly looking welds,lol....I'll get it on the car later this week...

Rotaryman88

I had to turn down the quality of the pics due to how big they were...sorry..but i'm sure the 56K guys won't mind...

1Revvin7

sweet, glad it arrived quickly and undamaged. You did get the BAC block off plate w/ it right? Lets see some installed pixs

Rotaryman88

Yea...got the plate too. I got 3/4 of it on today before work. Just gotta put the driver's side muffler on. It looks like it was made for a one-time application, lol...the muffler was a bitch to go on right...and i stripped one bolt, no biggie, it's only temp cuz I didn't have gaskets for the muffler to ypipe connection...





i got a ? for ya though...its supposed to sit evenly in the slots in the bumper right? Right now my passenger muffler is up high enough, but too far right(against the fender)..i'm assuming when i get the other muffler on it'll pull the other muffler over to be even..if not...i can adjust it at the ypipe most likely...i'll get pics tom...

1Revvin7

Yea you have to play with it at the Y section, I know I have had to play with it before to get it to sit right, it should tho. They sat perfect on my car...

Rotaryman88

Yea...actually..i was in a rush so i forgot to mount the RB ypipe bracket...so I think that may help a little too...i'll have to see..its supposed to be nice tom...so i should get it all up and done and get the BAC valve BOP on too...i'm sporting the single exit exhaust right now,lol...it actually doesnt look THAT bad...

1Revvin7

haha, yea I had that for a while

ROTARYROCKET7

nice exhaust man.