where to get them? i need the Oring that goes in the front of it that goes to the IC and the rear that goes to the flange that goes between the TB and flange that goes to the UIM

smoke buddah!

TO BE THE BADDDDDDD MAN

what the **** o_O https://www.nopistons.com/forums/pub...1047683561.gif





drunk bastages

to get the gaskets for the tb u need the spacerplate u cannot get just the gaskets unfortunatly. as far as the o-ring goes shoot if i look at work i prolly can get u one for a few bucks im sure

i have the spacer....but isntt there a paper gakset between the spacer and the TB itself?

if not then all i need is that oring....if you can get it ill pay you ASAP i need it ASAP

I don't even remember posting that??? https://www.nopistons.com/forums/pub...1047683561.gif https://www.nopistons.com/forums/pub...1047683785.gif

Why can't you? I have no need for the vaccum lines now. I run my lines from the bottom of the upper manifold for my BOV and boost gauge. The brakes are off of the side of the upper and my wastegate is off of the turbo. So technically I could get rid of it, right??



Since we are on the subject of gaskets, where can I find the upper and lower manifold gaskets? I have looked everywhere except the last possible place I could think of and hope that its not from them, the Mazda dealer.

i dont know why you cant get rid of the spacer....other than no gasket in between the UIM and TB and that they would prolly fuse togther.....id keep it there though



those are easy gaskets to find.... mazdatrix....atkinsrotary....they should have it