Mazdatrix Short Shifter
#12
Originally Posted by phinsup' date='Mar 1 2005, 08:41 PM
Anyways, mine only rattles at certain high rpms, but I can make it stop by applying pressure to the shifter. Sucks that you had to grind yours to make it fit. Mine shifted really notchy at first*, but seemed to break in after a week or so.
*I typically shift into first while still rolling backwards, and I couldn't get it in first unless the car was absolutely still.
#13
Originally Posted by phinsup' date='Mar 1 2005, 08:02 PM
OK, keep in mind this is my 3rd short shifter from them that I have installed.
Went to throw this one in and even though the shifter would drop in, it would not shift or center. So I clean out the linkage really good, still no help. I end up grinding a small amount (i hit the stock and the ss with calipers and found the ss to be .10 larger).
Ground it down and bam works great, I was pretty pissed as a 10 minute ordeal turned out to be a 2 hour ordeal as I had to shave just a bit at a time, then test, etc, etc...
Anyone ever have a similar issue? Anyone ever wonder if that being just a little out of spec or a little worn on the linkage side could cause the rattling? To small would seem to rattle between the linkage and the shift lever ball... now I need to conduct an experiment.
Went to throw this one in and even though the shifter would drop in, it would not shift or center. So I clean out the linkage really good, still no help. I end up grinding a small amount (i hit the stock and the ss with calipers and found the ss to be .10 larger).
Ground it down and bam works great, I was pretty pissed as a 10 minute ordeal turned out to be a 2 hour ordeal as I had to shave just a bit at a time, then test, etc, etc...
Anyone ever have a similar issue? Anyone ever wonder if that being just a little out of spec or a little worn on the linkage side could cause the rattling? To small would seem to rattle between the linkage and the shift lever ball... now I need to conduct an experiment.
NO ****, i had that same prooblem then i spoke to some guy at KD rotary in PA, he said do that same ****, and it works fine now
#15
Originally Posted by phinsup' date='Mar 1 2005, 08:32 PM
#17
Originally Posted by phinsup' date='Mar 2 2005, 02:36 PM
there was one for sale on here like 2 days ago. $100 used not shipped
Thread
Thread Starter
Forum
Replies
Last Post
arkadyzv
RX-7 & RX-8 Parts For Sale & Wanted
1
11-09-2006 02:39 PM
ZeroRX7
RX-7 & RX-8 Parts For Sale & Wanted
2
05-20-2005 03:56 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)