how to get transmission installed
#23
Originally Posted by banzaitoyota' post='802066' date='Feb 15 2006, 09:17 PM
Rob, the MUG bottles have a slippier coefficient of slipericity which provides superior fluid transfer cabapility. 9 out of 10 aborigini's agree!
I think the root beer bottles are made to handle more pressure, rootbear is a very fizzy soda.
I bet a seltzer bottle would have done the job faster
#24
Originally Posted by Rob x-7' post='802063' date='Feb 15 2006, 09:09 PM
how about a pepsi bottle?
or a sprite bottle?
think they would give the same results?
Plus Pepsi is just nasty.
#26
Originally Posted by drunkin_idiot' post='802292' date='Feb 16 2006, 08:59 PM
god I hate clutch jobs, took me 12 hours do do mine with bigturbo74 helping me the whole time, right before we were about to say **** it and call it a night, it slid right the **** in.
did you drink root beer before or after?
#28
a few years ago i was helping do a clutch job, we had the same problem, could only get within an inch, re-centered the clutch a few times
turned out the first time we were lining up the tranny, it caught the bottom of a heatshild near the shifter housing, and was actualy just getting caught there
so many hours wasted..
turned out the first time we were lining up the tranny, it caught the bottom of a heatshild near the shifter housing, and was actualy just getting caught there
so many hours wasted..
#29
I think when the dude said something about fill thru the shifter was refering to ... the way I fill mine. I shoot a tube w/funnel attached from inside the car thru the shifter hole/access down to the fill hole .... more direct than from engine bay ... if cut to the proper length the funnel is suported by side of tranny n tunnel ... easier for me than pumpin n tryin not to tip over qt bottle n pull tube out ... just my 2 cents as long as it gets in there ...
KK
KK
#30
your a ****** for using a root beer bottle, use a welch's grape soda bottle. in the future, stick the driveshaft in the back if the tranny and spin the drive shaft until the input shaft slips in. you are weak, i just bench the mother ****** up in there spin the driveshaft and "click" it slips in, its worked 5 times (many clutch changes)