High Idle
#1
ok well the car starts fine just did some minor changes since the last time it ran
problem with the car is it stays at 1500 idle and doesn't come down even when it's warm, it's idling roughly and backfires quite a bit in neutral on deceleration and also decelerates slower then it used to
it's a n/a 87 with 10,000 KM on the engine
i have BUR9EQ plugs in all 4 but it's been like that since last october and was like that last week when i ran it
the only changes since last time it ran are I bypassed the heater core since it's fucked(coming out the engine and right to where it comes back out the firewall) and its running 89 octance when i always ran it at 87
doesn't smoke, nothing else is abnormal smells like it might be running a little richer then usual but not sure
any ideas
could it be a combination of cold plugs with 89 oct. ? could bypassing the heater core have anything to do with it??
problem with the car is it stays at 1500 idle and doesn't come down even when it's warm, it's idling roughly and backfires quite a bit in neutral on deceleration and also decelerates slower then it used to
it's a n/a 87 with 10,000 KM on the engine
i have BUR9EQ plugs in all 4 but it's been like that since last october and was like that last week when i ran it
the only changes since last time it ran are I bypassed the heater core since it's fucked(coming out the engine and right to where it comes back out the firewall) and its running 89 octance when i always ran it at 87
doesn't smoke, nothing else is abnormal smells like it might be running a little richer then usual but not sure
any ideas
could it be a combination of cold plugs with 89 oct. ? could bypassing the heater core have anything to do with it??
#8
ok i bled the cooling system haven't started it yet cause i know there were some other problems like rough idling and slow deceleration at idle anyone know why that might be happening??
again non of this was happening b4 today
again non of this was happening b4 today
#9
comon guys i know one of you has the answer to this problem hidden somewhere around here...
gonna try some stuff out of the ID10T manual today see if i can correct anything
please, I'd appreaciate any input
Thanks
Frank
gonna try some stuff out of the ID10T manual today see if i can correct anything
please, I'd appreaciate any input
Thanks
Frank
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)