Help Pushing Power Out Of My N/a
07-08-2003, 11:29 PM
#1
Senior Member
Thread Starter
Join Date: Jun 2003
Location: Columbus, Ga
Posts: 233
07-08-2003, 11:44 PM
#3
Senior Member
Join Date: Aug 2002
Location: Mike is a Liar!
Posts: 4,848
Getting a turbo engine would be the best option.. probably cheaper too...
As far as engine mods go, eliminate all unnecessary junk, get headers, straight through exhaust.. and thats as much as I know.. but a good start..
As far as engine mods go, eliminate all unnecessary junk, get headers, straight through exhaust.. and thats as much as I know.. but a good start..
07-09-2003, 03:38 PM
#7
Senior Member
Thread Starter
Join Date: Jun 2003
Location: Columbus, Ga
Posts: 233
this is my first time building a rotary can i run just headers or do i need backpressure what all mods can i get all i know of is nitrous porting exhaust and fuel i mean **** no 513 lift cams or 10:1 pistons stroker kits cant bore it the only thing i have on now is long tube headers and a port job just asking for info on what all mods i can do dont have to get all pissey
07-09-2003, 03:59 PM
#9
Senior Member
Join Date: Aug 2002
Location: Eastern PA
Posts: 1,801
who did the port and rebuild job, you? If you spent all that money on a monster port job on an NA motor, why would you want to then do a turbo swap and lose all that money or are you thinking now of boosting the NA?
With the right porting, exhaust, fuel, and intake set up (such as Webers, etc), 250HP is doable NA for lots of green.
With the right porting, exhaust, fuel, and intake set up (such as Webers, etc), 250HP is doable NA for lots of green.
