Help! Please God Please
10-22-2003, 07:58 PM
#13
Senior Member
Join Date: Apr 2002
Location: IL
Posts: 2,930
check to see that you are getting good voltage at the leading and trailing coils, the black & yellow wires. Watch it while someone cranks the car.
has your switch been installed this whole time that the thing is misbehaving? Where did you tap into the wiring?
has your switch been installed this whole time that the thing is misbehaving? Where did you tap into the wiring?
10-22-2003, 08:51 PM
#14
Senior Member
Thread Starter
Join Date: Jun 2003
Location: Columbus, Ga
Posts: 233
j-rat where would i get one at ? apex13b why would i need to compression test a rebuild dont mean to sound like an *** just want to know why i would need to. i did not have a problem with spark till after i took the engine out i did nothing with the ecu im thinking a loose ground somewhere because it would be unlikely for both the coil/ignitiors to go out and i did not **** with the ecu the ignition switch is fine and the cas works. what grounds do i need to check out? pengaru i installed the switch about 3days ago and i taped the black wire /w white stripe under the dash i read it off iluvmyrx7
10-22-2003, 10:21 PM
#15
Senior Member
Join Date: Oct 2001
Location: Peoria, AZ
Posts: 10,906
https://www.nopistons.com/forums/ind...howtopic=12905
Same thing happened to Bigturbo74's car, it was flooded so bad, that he had to do the unflooding trick several times, and not to mention his spark plugs weren't too hot. You do have Ngk's right?
Same thing happened to Bigturbo74's car, it was flooded so bad, that he had to do the unflooding trick several times, and not to mention his spark plugs weren't too hot. You do have Ngk's right?
10-23-2003, 03:06 AM
#17
Member
Join Date: Jan 2002
Location: Tucson Az
Posts: 35
Originally Posted by FrostRacing' date='Oct 22 2003, 05:51 PM
j-rat where would i get one at ? apex13b why would i need to compression test a rebuild dont mean to sound like an *** just want to know why i would need to. i did not have a problem with spark till after i took the engine out i did nothing with the ecu im thinking a loose ground somewhere because it would be unlikely for both the coil/ignitiors to go out and i did not **** with the ecu the ignition switch is fine and the cas works. what grounds do i need to check out? pengaru i installed the switch about 3days ago and i taped the black wire /w white stripe under the dash i read it off iluvmyrx7
