I just put in a new walbro fuel pump, and i just recharged my diying battery. When i go to turn on my car i dont hear the fuel pump repressurizing or anything and the car wont start wutsoever. I think the fuel pumps just not active. Is there anything i should checK? Besides the fuses in the engine bay? I think most of them are good but an egi one egi isnt looking to healthy, and also one is fuse is a 30A where it should be a 40. If anyone has any suggestions please let me know thanks alot.
|
the fuel pump doesnt run when you turn the key on. the engine has to be spinning
mike |
so its basicly not even turning over ?
|
yea not even turning over. Since i changed fuel lines and fuel pump theres no fuel in the lines wutsoever. I also heard that its supposed to repressurize for like 20 seconds when the key is at the on position.
|
Originally Posted by Kuhrazy7' date='May 29 2003, 08:50 AM
yea not even turning over. Since i changed fuel lines and fuel pump theres no fuel in the lines wutsoever. I also heard that its supposed to repressurize for like 20 seconds when the key is at the on position.
mike |
O OK thanks alot man
|
the connector is yellow btw, should be close to the boost/pressure/map sensor
mike |
I don't have that connector on my car https://www.nopistons.com/forums/pub...1047683561.gif
|
check alll connection to make sure u didn't make a mistake ....ground ...power connection....wires is not broken ..was it workin b4 u in stall that one....
|
yea it was working before that, but the pump died. After the pump died. And i installed the walbro i havent been able to turn it on. O yea about the test connector, how do i jump it? I put wire from one slot to the next turn the key on and no dice. Am i going about this right?
|
All times are GMT -5. The time now is 03:39 AM. |
© 2024 MH Sub I, LLC dba Internet Brands