NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   engine probs on FC3S (https://www.nopistons.com/2nd-generation-specific-17/engine-probs-fc3s-54060/)

steitzybear79 10-27-2005 09:33 PM

I've noticed lately that my turbo isn't spooling up like normal. The engine is also blowing a lot of white smoke if I really get into the gas. It also gets very sluggish when the tach hits about 5,000 rpm. Does anyone have any suggestion https://www.nopistons.com/forums/pub...1047683561.gif s for me. I'm in need of some help, BAD!

RONIN FC 10-28-2005 08:47 AM


Originally Posted by steitzybear79' post='773400' date='Oct 27 2005, 10:33 PM
I've noticed lately that my turbo isn't spooling up like normal. The engine is also blowing a lot of white smoke if I really get into the gas. It also gets very sluggish when the tach hits about 5,000 rpm. Does anyone have any suggestion https://www.nopistons.com/forums/pub...1047683561.gif s for me. I'm in need of some help, BAD!

You might need a turbo. Take off your intercooler and see if it has oil in it.

One320B 10-28-2005 09:31 AM

That sounds like a busted turbo. Pull the intake system off all the way down to the turbo inlet and check the turbo... how bad is the endplay? how bad is the shaft play? pull the intercooler, check for oil in the intercooler lines, you can also check to see if there is oil on your exhaust tips...



..you said it was white smoke though and usually oil is a blueish color...white could be coolant. Has the car overheated lately at all? How many miles are on the engine?

steitzybear79 10-28-2005 01:15 PM

The engine hasn't come close to over heating. Its got 139,000 on the motor. I've been running th car like normal and here the past couple days everything is running fine after the engine is warmed up. I'm soo confused. https://www.nopistons.com/forums/pub...R#>/unsure.png

RONIN FC 10-28-2005 01:24 PM

You take the intercooler out yet?

steitzybear79 10-29-2005 01:57 AM

Not yet, but I figure that will be my weekend project. Its my everyday vehicle and through the week I need it so...you know how that goes. I'll be looking into it this weekend. Thanks for the help guys.

chrisgen2 11-03-2005 10:48 PM

You should check the compression levels in your rotor chambers.

-I had a similar problem, blowing a lot of white smoke, a strange hesitation on the rpm ride, and it turned out that I had zero compression in one of my chambers due to an apex seal breaking off the rotor and ripping around the housing... it was not a good look.


All times are GMT -5. The time now is 03:35 PM.


© 2024 MH Sub I, LLC dba Internet Brands