CS Header -> RB Pre-Silencer -> ?
#1
So I've installed a CS collected header to a RB pre-silencer (2.5in) to a CS catback(80mm), but it is much too loud. So, I'm going to replace the CS muffler with something a bit more substantial and wanted to see if anyone has a similar setup or could comment on mufflers that would bring the noise level down to bit louder than with just a CS catback at cruise and light throttle.
Current contenders are:
Large Magnaflow straight-through
Magnaflow Turbo XL
Moroso Spiral Flow
With a 80mm pipe on a NA I figure I could get away with the Turbo XL and not kill perf, but have read about them splitting or not sounding great.
A large Madnaflow straight-through would be good for Perf. and likely sound good under accel. but something large enough to bring down the volume would likely be heavy and potentially obnoxious under daily driving conditions.
The Moroso Spiral flow would be a "semi-baffled" muffler which seems like a sweet spot but I have read reviews that their durability isn't up to snuff with NA rotary heat.
I've also considered DNA & Aeroturbine mufflers but they seem a bit gimmicky for the $$. I know Borla is nice, but for less price a Magnaflow has essentially the same design and similar construction.
Comments? Sound clips?
Current contenders are:
Large Magnaflow straight-through
Magnaflow Turbo XL
Moroso Spiral Flow
With a 80mm pipe on a NA I figure I could get away with the Turbo XL and not kill perf, but have read about them splitting or not sounding great.
A large Madnaflow straight-through would be good for Perf. and likely sound good under accel. but something large enough to bring down the volume would likely be heavy and potentially obnoxious under daily driving conditions.
The Moroso Spiral flow would be a "semi-baffled" muffler which seems like a sweet spot but I have read reviews that their durability isn't up to snuff with NA rotary heat.
I've also considered DNA & Aeroturbine mufflers but they seem a bit gimmicky for the $$. I know Borla is nice, but for less price a Magnaflow has essentially the same design and similar construction.
Comments? Sound clips?
#4
absolutely do not use a Morose spiral flow.... been there done that yes they are cheap but it will rattle till you beat the **** out of it with a hammer....
I use two Mac Flow Paths at the back with some nice magnaflow tips, I have just a short bullet muffler up ahead of them with an aero turbine up under the middle.
I use two Mac Flow Paths at the back with some nice magnaflow tips, I have just a short bullet muffler up ahead of them with an aero turbine up under the middle.
Thread
Thread Starter
Forum
Replies
Last Post
Jerk_Racer
RX-7 & RX-8 Parts For Sale & Wanted
4
02-18-2003 06:27 AM
RotaryRocket219
RX-7 & RX-8 Parts For Sale & Wanted
7
02-04-2003 11:48 PM
Chewbacca
RX-7 & RX-8 Parts For Sale & Wanted
1
07-03-2002 03:00 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)