Houstonderk

Alright, so I finally had my Tii back and running and for some reason it will not rev higher than 4000. So I looked up the codes and found the tps. So when it was running, I tried turning it off quick by disconnecting the AFM but it stayed running. Then I took all the tubing and looked at the wheel in the turbo just spinning while the car was on. Isn't the car supposed to stall out when I do this?

djgiantrobot

if you disconnect the MAF it'll still run in limp mode most of the time.

teknics

I dunno, disconnecting (unplugging) the AFM should activate the fuel switch inside the AFM which would stop fuel from going to the motor.



kevin.

CrassFC3S

it really should not run with the afm off, i mean even covering the AFM should kill it or come very close to killing it.

djgiantrobot

hmm, maybe S4 and S5 are different? I dunno i haven't had an MAF on an rx7 for several years now.

drunkin_idiot

How the **** are you pulling that off, EMS?

djgiantrobot

yeah standalones

drunkin_idiot

Ohh ok I was like htf are you running no afm without standalone.