Originally Posted by Rotaryman88' date='Mar 7 2003, 07:43 PM
Do you have the tranny bolted up yet? It's hard to tell from that pic...what kind of clutch you goin with?
|
Cool, what job do you do? BTW...got the PM..that deal for shipping sounds fine. ACT does sell a pretty decent puck setup too...and puck clutches are typically cheaper from ACT then their Street units...I saw a 6puck somewhere for $265...not bad..
|
I am a cashier at a flower store https://www.nopistons.com/forums/pub...>/rolleyes.gif ahah would have never figure, but i might have a new job opportunity to work w/ cars and make real money, https://www.nopistons.com/forums/pub...DIR#>/ohmy.png !! Oh yeah finally got a decent gauges pic. I will look into act's clutchs...
|
Damn...my boost guage doesn't go as high as yours....
i only plan on going 20psi at the max...u? |
looks good, can't wait to see the videos of it coming to life https://www.nopistons.com/forums/pub...#>/biggrin.png
i'm surprised you havent removed the stuff on the UIM that looks like junkyard identification markings? |
whats the black thing on the firewall between the wiper motor and the MAP sensor?
|
Originally Posted by pengaru' date='Mar 7 2003, 08:08 PM
whats the black thing on the firewall between the wiper motor and the MAP sensor?
|
Wire brush, optimally on the end of a drill.
|
Originally Posted by 1Revvin7' date='Mar 8 2003, 07:21 AM
electronic boost sensor, for my gauge. What can I do to remove that "junkyard identification" markings? Any Ideas, yes i want to get rid of them...
I'm guessing they use a sort of paint marker at the junk yard, maybe any sort of paint remover will work. Rob could probably tell you exactly what to use to effortlessly remove it. If you take a wirebrush to it, you'll be starting down the polished manifold route because the area you hit with the wheel will no doubt start shining. |
Originally Posted by pengaru' date='Mar 8 2003, 02:47 AM
isnt it kindof annoying that you need another boost sensor for a gauge when the haltech already has the data ready to be sent out on the serial port? https://www.nopistons.com/forums/pub...#>/biggrin.png
I'm guessing they use a sort of paint marker at the junk yard, maybe any sort of paint remover will work. Rob could probably tell you exactly what to use to effortlessly remove it. If you take a wirebrush to it, you'll be starting down the polished manifold route because the area you hit with the wheel will no doubt start shining. |
All times are GMT -5. The time now is 02:48 AM. |
© 2024 MH Sub I, LLC dba Internet Brands