Who's tuning ur Microtech for u????



I also noticed u chose the LTX version...did you go w/ the bosch coils??

 

i wouldn't even know where a local dyno is

 

Pineapple Stage II

9.5lb RB flywheel

Stock ECU

Stock Exhaust, gutted cats

TB modded by removing plates

No Emissions

Evans NPG+

Pineapple Sleeves

Cleaned and Tested Fuel Injectors (by Marren Fuel Inj)





108 HP/107 Ft-lb torque.....

It appears that the 6 ports are not opening/operating properly. Think is a DOG to REV.



Another Problem is the 3.9 Non-LSD rear-end.



Will troubleshoot the 6-ports sunday. Since I am installing the LTX-8 soon I will go ahead and wire the RPM switch up with an Electric Airpump to actuate the 6-ports. Updates to follow. A very frustrated Banzai

 

Can you try tieing them open? Has this fresh motor built all its compression yet?

 

is that pretty much asking if its broken in yet?

 

Basically...

 

then building compression is just a little bit of breaking in a motor?

 

I applaud your efforts and results will come. Hope to see you on the 6th and your welcome to review how I have my 6 ports set-up to give you some ideas and also help me verify that that and the VDI is working properly. Keep up the good work!



Ken

 

Well as I suspected the 6 ports aren't working correctly. I am going to actuate with an electric airpump

 

Hope you get some good results.