I've been in a pic posting mood today, lol...see the "General Discussion" forum and you'll see what I mean.



I got my Boost and air/fuel guages today and put them in my guauge pod that I've had for about a year now!!! That 20PSI mark will be laughing at me until I can build my motor up to handle that!

I feel the same way...my boost gauge goes up to 25 psi.

Where did you get the gauge pod I have been looking for one that will go onto the drivers side window sill/frame but have not had any luck.

http://www.summitracing.com sells them. Check out Autometer's web page for the part numbers.

I see them listed for 86-89 7's. What about the 90 and 91. Does anyone make them?? Are they different?? :notify:

I have an Autometer Tacho for my RX3, The bloody thing only works when it feels like it. It was sent back to Autometer and they said nothing was wrong with it after an auto electrition couldn't get it it to work. I have checked the earth wire and all the other wires and its all hooked up okay but still no good, any ideas?

89-91 would be different for coupes because of the automatic seatbelts, but I think that people have used the 86-88 pod on them.

I hate automatic seatbelts. Especially since mine just broke. I would like to get the a pillar gauge pod but don't know if anyone makes one that goes right in without modifications.



:madgo:

The 3rd gen pod might fit.

Mine pisses me off too. When the shift light comes on, the damn needle jumps all around. This is the 2nd unit - sent the first back to Jeg's. I have good grounds and power source, and it still gets wacky!