NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   5 beeps from computer (https://www.nopistons.com/2nd-generation-specific-17/5-beeps-computer-68300/)

ShadowArtsFC3S 12-01-2007 10:16 PM

I was wondering if anyone could tell me what that means? It goes beep beep beep beep beep.....beep beep beep beep beep. I just installed a new steering wheel with out a horn I was thinking that could be it. Also, I need to know why my car idles like it needs a new TPS on cold start, but when the engine is warm it idles just fine. Let me know. Thanks.



-Rich

RX7 13B 4 UR AZZ 12-02-2007 05:21 PM

the warm/cold thing could be a bad water temp sensor making the computer add correction like if it is always warm even when cold ! ! !

Rob x-7 12-03-2007 05:15 PM

I think the beeping is the power steering. Check the fluid



a out of spec or out of ajustment TPS could cause either a good cold start but poor warmed up or vise-versa.

ShadowArtsFC3S 12-07-2007 08:29 PM

TPS sounds about right. Its friggen annoying. I just bought the car 2 weeks ago. So, now its my problem to fix. It should be fixed by sunday. Then its going away for the winter.

ShadowArtsFC3S 01-19-2008 05:27 PM

I still cant figure it out. Would it be low oil pressure?

KompressorLOgic 01-19-2008 08:20 PM

the beeps are problems with the power steering system, the PS throws codes in the form of beeps ranging from 1-5.



since you mentioned u just switched steering wheels, if you misalign the steering wheel angle sensor this would cause the problem. Do your turn signals still shut off after your done turning like they used to?? if they dont then its definitly not aligned corectly.

ShadowArtsFC3S 01-21-2008 04:03 PM

That is probably it. The steering wheel is deffinalty not aligned properly. And no the turn signals dont turn off automaticly. Rigth now I'm more worried about getting the damn oil pan off. Why would they make the oil pan go directly over the front subframe? I'm honestly think about lifting the motor out a couple inches to get at the front bolts on the oil pan. If I align the steering wheel would the make the turn signals shut off after every turn? And how do I align the steering wheel so its perfectly straight.

ShadowArtsFC3S 01-22-2008 07:06 PM

That was the problem. Thanks KompressorLOgic for the help, and thanks everyone else for their input. I appretiate it.



-Rich

teknics 01-25-2008 05:36 PM

the bad idle when cold thing could be due to an improperly working thermowax/ removed thermowax on the TB.



kevin.


All times are GMT -5. The time now is 03:10 AM.


© 2024 MH Sub I, LLC dba Internet Brands