i can look at mine, i'm not even sure what the motor failure box does



mike

Mainly wondering if and where those two go and if I need to custom wire them in.



Luis

If it helps any mine doesn't have any of those but it's not a turbo; so I'm not sure I would assume just the knock controller,

there should be a plug off the computer the dash harness one to plug into the knock controller. I would think anyway... If not

then I don't know I could always get the workshop manual again and find out

I have the haynes paper wieght.I should be able to see where it goes on the EGI diagrams.:DI just think that the knock control should be on the engine harnes and inline with the knock sensor.

That's what common logic would tell you but after doing the swap if you learn one thing it's that some of the wiring is so funny that if you can think of the

hardest, most expensive, biggest pain in the ass way of doing it; then that's probably how it's suposed to be... I will try to get the workshop manual,

because I think I'm going to have to rewire my fuel pump, with the open circuit relay and afm...