eshaft puller..
anyone know where one can get it for cheaper than 850 from mazdatrix...
|
Re: eshaft puller..
Originally Posted by amp
(Post 852618)
anyone know where one can get it for cheaper than 850 from mazdatrix...
Lynn E. Hanover |
Re: eshaft puller..
I made one from about a foot of 3" sch 40 pipe.
Used the pipe, welded a 3" square of flat plate (1/4" thick), 1/2" threaded rod to bolt a OTC "H beam puller" to. Welded 1/2" rod to a stock oil line banjo fitting (threads in to the e shaft lobe). Essentially the pipe drops over the shaft like the Amemiya video and pulls against the main e shaft. Notes, do not use a cheap puller. I tried an 8" 3 jaw from ebay, welded it to the pipe. Failure, threads are **** and stuck. Even with the OTC H beam, 8 or 10 ton if I remember right, I could not get it with out heat. I heated it gently and at a distance with a large air/acetylene torch. Good luck. |
All times are GMT -5. The time now is 01:32 PM. |
© 2024 MH Sub I, LLC dba Internet Brands