if any one has any info it would be greatly appreciated.
i have a 75 toyota corolla with a 12a and tranny from a 84 rx7 i put in a chevy s10 blazer rearend in it but the stock s10 gears were too rough on the tranny it was tough to get the car moving off the line unless in high rpm i also blew the tranny on the first long ride with it i am going to put in an lsd in it and change the gears in it since i can find the parts easy er now my question is does any one know what ring and pinion gears i should use given the fact that it is a heavy rear end over all i am also running 17" wheels engine is stock with a holly 650 and 3 coil ignition i want to be able to break the tires loose and get the car going side ways but also not have the car too reved out on 5th on long trips thanks again for any help |
sorry guys my comp would not show me the post went through didnt know i put it in so many times
|
stock on the 12a was 3.9. a 4.1 would be nice came on GSLSEs. 4.3 might be a lil too much for what youre looking for.
check the table at the bottom of the page for a tad more info. http://rx7.com/store/rx7/fddrivetrain_rearend.html |
All times are GMT -5. The time now is 01:36 AM. |
© 2024 MH Sub I, LLC dba Internet Brands