Thanks Ben. I've looked over here a few times, and I thought that I would try these guys out. I hope the drama stays away from here!

no it dosnt.. and i believe you payed me to turbo prep you nikki so you did not do everything yourself https://www.nopistons.com/forums/pub...IR#>/smile.gif



another 12a turbo nikki under the masters belt





i believe my first 12a turbo nikki was born on 1-7-95



i have also made the highest hp with a turbo 12a blowing through a nikki bck in 98, it was 540 rwhp to be exact



you can get alot of hp out of a 12a, my last dyno session approx 5 years ago netted 730rwhp



since then i have been limited to working on my car as i struggle to keep up with bussiness as bad 83 cat confirm..

im going to be here alot more so if anybody has questions, i have tons of expierience and am here to help!

Actually the carb that was sent to you took 5 months to get back, and it was so poorly done that I couldn't use it and wound up using another carb that I boost prepped myself. So like I stated earlier, I wish the drama would have stayed over there, but since some people can't tell the truth, then I guess the drama continues. This is why I do EVEYTHING myself, becuase people like this think they are the only ones who can do this.

They can't tell the truth cause it would make them look bad...unless they have cajones.

*SIGH* https://www.nopistons.com/forums/pub..._DIR#>/doh.gif https://www.nopistons.com/forums/pub...DIR#>/Wow1.gif

here is a short video of a 12a turbo with a nikki blowthrough setup



http://myspacetv.com/index.cfm?fuseaction=...p;videoid=22340

your Robert from rotary shack???

yes sir that is i......

p.s. nice rotary collection you have!

I have talked to you on the phone a couple of years ago? anyway are you doing that on a stock rear?

no way!! its a built ford 8.8 , 33 spline axles lightened spool, c-clip eliminators wilwood disk brake kit rear main cap girdle.... its bullet proof



i went low 11 sec passes on the stock rear end geard up with 4.88's but i did twist lots of axle shafts