new FB owner need help
#1
is there any short shifter that will fit in my 84 GSL-SE 13b engine dont really know the transmission just yet
was wondering if anyone knew how i could order this body kit as i really love the look of it https://www.nopistons.com/forums/rx7-le-man...kit-t60387.html
my gas guage is stuck a zero what would be causeing it
my engine idles at like 200 to 300 rpm is that normal or really low jsut seems stupied low to me thank you ot all that replie
was wondering if anyone knew how i could order this body kit as i really love the look of it https://www.nopistons.com/forums/rx7-le-man...kit-t60387.html
my gas guage is stuck a zero what would be causeing it
my engine idles at like 200 to 300 rpm is that normal or really low jsut seems stupied low to me thank you ot all that replie
#2
Go to www.sterlingmetalworks.com and read up on the tutorial for how to tune the idle speed and mixture. Lots of great info over there....
#3
Originally Posted by lonedraak' post='922085' date='May 25 2009, 10:57 PM
is there any short shifter that will fit in my 84 GSL-SE 13b engine dont really know the transmission just yet
was wondering if anyone knew how i could order this body kit as i really love the look of it https://www.nopistons.com/forums/rx7-le-man...kit-t60387.html
my gas guage is stuck a zero what would be causeing it
my engine idles at like 200 to 300 rpm is that normal or really low jsut seems stupied low to me thank you ot all that replie
was wondering if anyone knew how i could order this body kit as i really love the look of it https://www.nopistons.com/forums/rx7-le-man...kit-t60387.html
my gas guage is stuck a zero what would be causeing it
my engine idles at like 200 to 300 rpm is that normal or really low jsut seems stupied low to me thank you ot all that replie
https://www.nopistons.com/forums/85-b13-sho...ter-t75349.html
#4
the gas guage deal is due to the float being stuck. I think if you remove the heat sheilds from around the tank on the driver side. Then on the driver rear fender theres a inner fender plastic thing. Once all thats gone you'll see two wires disconnect them remove the screws and pull the float out. It will probablly be real nasty. If it cant be done like that than you'll have to dropp the tank. But I wana say it can be done with out going that far. If the float has to be replaced again I think there all the same as long as its 84-85
Thread
Thread Starter
Forum
Replies
Last Post
1994R2
RX-7 & RX-8 For Sale
1
02-17-2008 02:13 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)