kiwi 1stgen project:)
10-03-2007, 08:32 PM
#1
Junior Member
Thread Starter
Join Date: Jan 2006
Posts: 29
hi just poppin to show my project. will be a long one i guess
heres what iv got.
my 84 1stgen. lots of work to be done.
sheet metal flare.
rear flare yet to be tacked on and blended in.
s4 t2 motor 90,000miles needs a rebuild i think.and the t2 tranny.
s4 turbo,upper and lower intake,2 tb's 1 stock and ones been modified,also theres a fuel pump dont think its the t2 one.
gsl-se oilpan and front cover,the are sensor thing,t2 starter and a lsd 3rd member.
alternator,bac valve,ballast resister,coil packs, t2 s4 ecu,primary injector rail,and some odd realay box,fuse block.
so thats what i have so far. theres plenty of work to do and i am short of alota parts to get this beast running and safe to drive.
heres what iv got.
my 84 1stgen. lots of work to be done.
sheet metal flare.
rear flare yet to be tacked on and blended in.
s4 t2 motor 90,000miles needs a rebuild i think.and the t2 tranny.
s4 turbo,upper and lower intake,2 tb's 1 stock and ones been modified,also theres a fuel pump dont think its the t2 one.
gsl-se oilpan and front cover,the are sensor thing,t2 starter and a lsd 3rd member.
alternator,bac valve,ballast resister,coil packs, t2 s4 ecu,primary injector rail,and some odd realay box,fuse block.
so thats what i have so far. theres plenty of work to do and i am short of alota parts to get this beast running and safe to drive.
10-04-2007, 06:38 PM
#3
Junior Member
Thread Starter
Join Date: Jan 2006
Posts: 29
Originally Posted by z-beater' post='884294' date='Oct 4 2007, 11:09 AM
Is that a FG hood? Where did you get the flares? Looking good.
nope just a plain old rx7 hood.
the flares were custom made sheet metal
and were on a stripped down parts car i was gettin rid off so i decided i liked them
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)