1st Generation Specific 1979-1985 Discussion

Hey everyone .. a few questions?

Thread Tools
 
Search this Thread
 
Old 11-22-2007, 10:44 PM
  #1  
Junior Member
Thread Starter
 
dons81's Avatar
 
Join Date: Nov 2007
Posts: 2
Default

Hey i just bought an 1981 Rx7 with a rebuilt to rotor engine that seems to run ok the only problem i find is when cold u have to hold it around 2500 rpms for a minute unltil it will run solid , and the weather stripping on the back window is shot and letting water in . any input on what reguraly goes wrong on this car so i could check / watch out for would be great ... oh before i forget the speedometer is shot bounces while driving could this be as simpile ad a fuse of more ..... alot of these problems are new to me for iam use to a much newer car ... lol ... THANKS ALL and all input would be much appreciated
dons81 is offline  
Old 11-22-2007, 11:44 PM
  #2  
Senior Member
 
Clarks7's Avatar
 
Join Date: Nov 2002
Location: Davis
Posts: 217
Default

Originally Posted by dons81' post='888472' date='Nov 22 2007, 08:44 PM
Hey i just bought an 1981 Rx7 with a rebuilt to rotor engine that seems to run ok the only problem i find is when cold u have to hold it around 2500 rpms for a minute unltil it will run solid , and the weather stripping on the back window is shot and letting water in . any input on what reguraly goes wrong on this car so i could check / watch out for would be great ... oh before i forget the speedometer is shot bounces while driving could this be as simpile ad a fuse of more ..... alot of these problems are new to me for iam use to a much newer car ... lol ... THANKS ALL and all input would be much appreciated




-Check the Choke...



-Check the drain holes in the corners (usually, you need to run something through them to unclog them).



-Is it the speedo or the tach? Speedo runs off a plastic gear on the tranny (1 10mm nut hold it in) and drives a cable directly to the speedo. Check to see if it is properly seated at both ends. Check the gear is not stripped or broken. Those are fine, it is the speedo itself... If it is your tach, check your ignitors...



It is a fun car, sounds like your problems are minor.
Clarks7 is offline  
Old 01-08-2008, 02:41 PM
  #3  
Junior Member
 
kev85rx7gsl-se's Avatar
 
Join Date: Dec 2007
Location: Foresthill, California
Posts: 13
Default

i know that if your looking for the weather stripping that there is a place called black dragon

www.blackdragonauto.com



they have all the strippings and parts that you could ever want, but prices are for new parts and are expensive. if you don't need new then search around for a parts car, because it will be a 100 times cheaper
kev85rx7gsl-se is offline  
Old 02-16-2008, 06:47 PM
  #4  
Junior Member
 
1st Stop Import Performanc's Avatar
 
Join Date: Feb 2008
Posts: 17
Default

Originally Posted by dons81' post='888472' date='Nov 22 2007, 08:44 PM
Hey i just bought an 1981 Rx7 with a rebuilt to rotor engine that seems to run ok the only problem i find is when cold u have to hold it around 2500 rpms for a minute unltil it will run solid , and the weather stripping on the back window is shot and letting water in . any input on what reguraly goes wrong on this car so i could check / watch out for would be great ... oh before i forget the speedometer is shot bounces while driving could this be as simpile ad a fuse of more ..... alot of these problems are new to me for iam use to a much newer car ... lol ... THANKS ALL and all input would be much appreciated
Try removing your speedometer cable from trans side grease it really good and push it back in. Check the drains in back and put on a new seal. If choke does not stay out then you may need a new choke cable assembly otherwise check to see if you have spark on leading and trailing during that initial start up, an ignitor may not be firing right away. Also check your carb adjustment.
1st Stop Import Performanc is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
the solitaire
2nd Generation Specific
9
10-28-2005 12:59 AM
Goukid
Meet and Greet
5
12-29-2003 04:41 PM
3rdGen7
Insert BS here
34
11-19-2003 12:01 AM
CSP12a
Northwest
6
12-10-2002 12:51 AM
JaySpec7
Insert BS here
8
11-08-2001 11:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


Quick Reply: Hey everyone .. a few questions?



All times are GMT -5. The time now is 05:21 PM.