NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   1st Generation Specific (https://www.nopistons.com/1st-generation-specific-16/)
-   -   Head Unit Instal (https://www.nopistons.com/1st-generation-specific-16/head-unit-instal-35716/)

jebenkurac 03-16-2004 10:00 PM

i need to remove the gray center piece from the dash. i know the ashtray, and all the knobs and dials come off, then what? id rather someone just tell me so i dont end up ripping it off and having to order a new one.

treceb 03-16-2004 10:46 PM

im guessing this is on a series 3? u need to remove the shifter panel/console to expose 2 screws. i believe all that holds them atop is 2 nuts that are behind the knobs for the temp control.

i think thats all, although its been a while since i took one off.

falcoln0014 03-17-2004 12:30 PM

you also have to reach your hand behind the colsole one you get the 2 screws at the bottom and the 2 nuts from the dials...it has 3 lights that you twist and pull out...one for the ciggy tray and one for each dial...after that it just lifts off



you'll also need an install kit...wal-mart sells one made of plastic that fits the hole...crutchfield also sells a really nice metal insert with a black plastic face cover...you can get that and the wiring harness adapters for free if you order a reciever from them



without the kit your radio will just set in the hole...not very attractive https://www.nopistons.com/forums/pub...R#>/tongue.png

treceb 03-17-2004 01:03 PM

rotorhead.ca has bracket for a radio and a cubby or 2 or 3 gauges made out of aluminum. i ordered one...



but other ppl have liked it and said it fit fine after receiving it...



also, i dont think they have, or at least i havent seen one, a wiring harness adaptor for the factory plugs.

jebenkurac 03-18-2004 08:58 AM

right now i dont even have anything that would use a gauge. does anyone make a carbon fiber three piece thing to replace the ashtray, shifter surround, and center console.



by the way, has anyone seen the new light-up 5 speed rx-8 shiftknob?

treceb 03-18-2004 01:47 PM

umm right now only factory consoles, at least none that ive heard off, unless u want to stick carbon fiber look-a-like tape on the console.





and i have one of the illuminated 5 sp rx8 knobs. for my FD, not installed yet though. im too lazy. as you would tell if i showed yall all the stuff i bought for my FB and never got to install...

jebenkurac 03-19-2004 01:52 PM

yea i was checking them out they look sweet as hell. the only thing is they onl;y come standard on the japanese rx-8's, so its probably a shitload of cash to get.

treceb 03-19-2004 02:46 PM

185. pm herbleny or check the group buy section.


All times are GMT -5. The time now is 02:05 AM.


© 2024 MH Sub I, LLC dba Internet Brands