I got a 1985 12a RX-7...and when I go to turn it over.. all of the lights and stuff and that annoying buzzer work...and when I turn the starter on it turns slowly and makes a squeeling noise. The car has been sitting for about 4 months or so. But all of the tuneup items on it are new (oil, plugs, wires, fluids, etc.) although I haven't replaced the dist. cap or the rotor. I called a guy at a mazda place up the road and he said to just put some tranny fluid in the trailing plug holes and crank it. To lube up the apex seals. So does this sound right or does someone else have a different opinion? https://www.nopistons.com/forums/pub...R#>/flamed.gif

well if it turns over slow its either the starter, or low battery, or maybe the cables/connections



mike

I thought it might be the starter...It's not really slow. It turns over faster than a dead battery but a little slower than norm. Just wish I knew what the squealing noise is. Thx bro

yah the noise is wierd too, i think the starter is dying



mike

The starter from a 83 is interchangalbe with the starter of a 85 right? both 12a

yup



mike

Cool thanks...Autozone here I come.

Just remember that 12a starters are interchangable and only 12a starters.I don't think the SE's 13b starter works.Then again the 13b flywheel is the same size so I could be wrong.

I got that taken care of, the starter now works. Problem now is..I think it's the fuel pump...

No gas getting to carb, no gas in check valve, there is gas in the line past the fuel pump and the filter (replaced the filter anyway). So I'm guessing it's the fuel pump. The drivers side had alot of water in it so I hope none of the wiring is screwed. Gonna replace it tomorrow..guess I'll post again afterwards.



Also that Hot Engine Starter Assist thing is making a wierd ass squealing noise...is that normal? I just disconnected it cause it's annoying as hell. My parts car (83) doesn't have one of them.



Does the fuel pumps in rx7's make that clicking noise when you turn on the ignition? https://www.nopistons.com/forums/pub...IR#>/boink.gif https://www.nopistons.com/forums/pub...IR#>/boink.gif https://www.nopistons.com/forums/pub...IR#>/boink.gif https://www.nopistons.com/forums/pub...IR#>/boink.gif https://www.nopistons.com/forums/pub...IR#>/boink.gif https://www.nopistons.com/forums/pub...IR#>/boink.gif

When you turn on the key before you start it you should be able to hear the pump operating.I know mine does.Let us know how it goes.



Luis