1st Gen Driveshaft
#1
Im looking to replace my driveshaft with a rebuildable type, and looking for an aluminum driveshaft. I want beefier u-joints that I dont have to worry about breaking and lighter rotating mass to further lighten the seven. Ive only seen one place that sells them and its Horsepowerfreaks.com but they want close to 500 bucks for it. Anyone know where I could get an aluminum driveshaft cheaper without getting......shafted
#3
[quote name='FB MAZDATURBO' date='Jun 17 2005, 11:04 AM']well any drive shaft shop should be able to build you one but i dont know what they will charge i know my custom drive shaft fot my mazda ran me 425 with a costom pinion flange to go with it. mine isnt aluminum either
[/quote]
daaamn, so why custom? what did you need it to fit or what material is it made of? sounds expensive for non-aluminum.......<span style='font-size:8pt;line-height:100%'>carbonfiber???</span>
[snapback]726758[/snapback]
[/quote]
daaamn, so why custom? what did you need it to fit or what material is it made of? sounds expensive for non-aluminum.......<span style='font-size:8pt;line-height:100%'>carbonfiber???</span>
#4
well it is made out of dom seamless tubing it had to be custom to do the TII trans to the first gen rear end with bigger u-joints and so on it is pretty light for being steel i also had a rear input flange done for the third member
#5
#6
[quote name='FB MAZDATURBO' date='Jun 17 2005, 12:18 PM']well it is made out of dom seamless tubing it had to be custom to do the TII trans to the first gen rear end with bigger u-joints and so on it is pretty light for being steel i also had a rear input flange done for the third member
[/quote]
so re-drilling the 3rd member and using the stock TII shaft wouldnt of worked? or changing the yokes on a first gen shaft? I've seen the TII tranny in a first gen a few times but didnt think it took that much trouble for the shaft to fit...................I said shaft...huh huh
[attachment=31891:attachment]
[snapback]726795[/snapback]
[/quote]
so re-drilling the 3rd member and using the stock TII shaft wouldnt of worked? or changing the yokes on a first gen shaft? I've seen the TII tranny in a first gen a few times but didnt think it took that much trouble for the shaft to fit...................I said shaft...huh huh
[attachment=31891:attachment]
#8
If you don't want to have to worry about the driveshaft breaking, I wouldn't go with aluminium. Steel is far less brittle and resists torque better so you can afford to have a smaller dia. driveshaft, meaning centrifugal force. If you want to spend money go for a carbonfibre driveshaft.
Mark
Mark
Thread
Thread Starter
Forum
Replies
Last Post
rx2tones
RX-7 & RX-8 Parts For Sale & Wanted
2
06-07-2006 06:02 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)