I have a prebuilt version 3 megasquirt with a new harness. The harness needs ends like injector plugs and various other plugs put on, but the other end the DB9 is already on. The megasquirt is already loaded with the fuel and spark standalone code. I have already put in the 3 pull up resistors on the l.e.d.s for the coils. I had it setup to where all you have to do is cut 2 teeth out of the cas. I will take $350 shipped with in the states o.b.o.



I also have an Xbox 360 with 9 games but one got messed up so it only plays about half of the game. I also have one demo disc. It is the premium system with the 20 gig hard drive. I have 2 wireless controllers and one wireless media controller. I have for games( Hitman Blood Money, Need for Speed Most Wanted, Project Gothem, Far Cry predator- 2 games in one, Dead or Alive 4, King Kong, Ghost Recon, Condemned, and the game that got messed up is Call of duty. You can play it for awhile.



I will take $475 +shipping. I had asked $600 to begin with but I really need to get my car running bad.

 

what else is need to get the megasquirt up and running on a s5t2,,will it controll fuel and spark,is it a standalone replace oem ecm,harness,mas (maf) with a map?

 

It is a full standalone. You don't use any mass air flow anymore. All you will need is a laptop to tune it. and to finish putting the ends on the harness. If you goto the rx7club.com forum they have a whole forum on megasquirt and a writeup on everything there. All you have to do on you car is take the cas out and take a drimel and grind down two oposing teeth. They have to be exactly across from each other. If you goto that forum you will get all the info you will ever need.

 

do u still have the megasquirt and is it a 2.2 3 0r 3.57 board on it