You can get the wastegate and the turbo on ebay. And they are cheap. But there manifolds suck. And they dont do one to suit s4 or s5 rx7 (if they did it probably wouldnt fit!) .

Well i make a manifold that fits . Its 304 stainless steel fully divided and takes the 50mm HKS rip off wastegate. An affordable set up for a street car looking for a bit more turbo than stock.

I can also do a manifold for fd rx7 . Manifold $ 900 NZ + shipping weighs 9lbs

hmmm how much is that in US dollar?

$1 nz = 68c US currency converter online can work it out exact.

how about manifolds for 12a ?

Yea no problem i have a 79 rx7 i can make a jig off. That turbo would be a good size for a 12a. What inlet manifold will you be using ?

I did a similar set up a few years ago . We used an adaptor plate and s5 rx7 intake manifolds. Had to use bigger secondaries with street port.

Is that the same as the Master Power T70?

Not sure it has KKK large T3 exhaust housing K27 compressor

i have a 80 sa with a racing beat intake manifold

Is that for IDA or Holley? Sorry for slow responce.