haha, yes it will. you know how it feels. i am stock piling (sp chk) and installing them as i go along. unfortunaly (sp chk) i will not be able to port the motor this year. i know a lot of people might disagree with what i am doing, adding the parts without porting, but unless they plan on donating money i have no choice.



luigi

wishing credit limit was unlimited like vosko

You can make good power on a stock motor. If its healthy, no point tearing it down just to port it unless you got money to burn

porting isn't necessary you can still make alot of power on stock FD ports... they are pretty big from the factory :bigthumg:

great to hear. but knowing my luck (vosko luck), somethings going to break.



luigi

Breaking parts is just a given... If your not breaking ****, your not making engough HP... kinda like my Mazda speed power plant frame that I just recently split in half.. https://www.nopistons.com/forums/pub...IR#>/boink.gif

Breaking parts is just a given... If your not breaking ****, your not making engough HP... kinda like my Mazda speed power plant frame that I just recently split in half.. https://www.nopistons.com/forums/pub...IR#>/boink.gif [/quote]

wow, I almost feel unlucky since mine is still intact https://www.nopistons.com/forums/pub...IR#>/boink.gif

i'm running a Kenne bell boost-a-pump in my supra hooked up to a hks pump (which everyone says is similar to a stock supra pump) and i dynoed at 600 rwhp. I think a boost-a-pump and stock fd pump should work. It adds a couple of volts to the charge. But due to the cost, $200, it might be better to just get an extra pump.



joe

I have the Aeromotive pump intank and it works great! It is louder than twin intank pumps, but not too bad. You cannot hear it over the exhaust anyway. I talked to the Aeromotive guys and they said the pump would be fine in the tank. I just did not want to weld the sump in the tank. The only thing that I have to be careful of is letting it get too low and getting on it. I have just made a rule for my self not to run the car hard if it has less then 1/4 tank. But when I had it running in the garage it pulled fuel just fine even with the low fuel light on. I figured better safe then sorry.

Nick

speed_nyc has a weldon pump OMG it is so loud. its ridiculous.... lol



my SX is external and completely streetable

I have the Desno Comp. Pump. How much will this pump support before I need to add an external pump to go along with it? I will be running a T78 with a Race Ported motor that should be here anyday. 550pri and 1600sec with a SX FPR -6AN lines and the Denso pump. Do I need to uprgrade my pump? I am going to be running 15-17psi until I replace my diff and PPF. Then I will install my 3bar MAP sensor and up the boost.