Lets see what everyone is running and what kind of numbers you are producing.
Generation: 3rd Turbo: apexi rx6 AR Exhaust: 1.0 Ported: streetport Boost: 15-20psi rwhp: yet to dyno 1/4 mile: yet to run |
You'll get lots of dyno and other stats when my car is done in 3 weeks, Dave says 340-360RWHP stock twins at 15psi.
Ken "94 PEP, White, Red Leather www.nopistons.com |
I've been waiting for dave's dyno for a few months. When it gets fixed I'll post my numbers as well. I might even go ahead and buy my own wide band, tune it myself and run it on another dyno just to see what kind of numbers I'm pulling. I'm shooting for 370 RWHP. We'll see...
|
Quote: from 94touring on 12:01 am on July 25, 2001 Lets see what everyone is running and what kind of numbers you are producing. Generation: 3rd Turbo: apexi rx6 AR Exhaust: 1.0 Ported: streetport Boost: 15-20psi rwhp: yet to dyno 1/4 mile: yet to run Generation: 2nd Turbo: T-76 Garrett A/R Exhaust: 1.15 Port: Bridge Boost: 30psi RWHP: 608 1/4mile: 9.67@141mph crispeed 87TII 9.67@141mph |
Crispeed,
Just curious, what fuel you use at 30psi, and if it's stock Comp, Ratio? -Les |
Quote: from lesd on 1:40 am on Aug. 16, 2001 Crispeed, Just curious, what fuel you use at 30psi, and if it's stock Comp, Ratio? -Les crispeed 87TII 9.20@150mph T-72@35psi 651RWHP/520RWTQ 2600lbs |
My new configuration. Should be completed and dynoed tuned by 9-14-01.
Ken "94 White, mods: Hayes street port & polished stage II, 3mm seals, T04e single turbo kit, GReddy SMIC, Aquamist 2s water injection kit, Pettit ss resonated mid-pipe, Pettit ss cat-back, RP Racing fuel pump, 1200cc injectors, Profec B, Centerforce clutch, under pulley kit(no air pump), Pettit short shifter kit, boost gauge, PFS PMC (10-psi,15-psi) I'm hoping to get these Dyno numbers: rpms t04e 2.0 045 2.5 075 3.0 110 3.5 165 4.0 230 4.5 290 5.0 320 5.5 350 6.0 370 6.5 395 7.0 400 7.5 395 www.nopistons.com |
hey cris...jsut out of curiousity why did your stats on you car change from the first post to the next?
|
well guys I finally dynoed my car but unfortunatly it didn't go as well as I hoped. I only put down 365rwhp and 352 lbs trq. I think the problem lies in the ignition, my trailing two isn't doing anything. Back to the dyno once I figure it out.
|
Generation: 3rd
Turbo: Greddy T78 AR Exhaust: ?? Ported: large street port Boost: 15-25psi rwhp: yet to dyno(hoping for atleast 450rwhp) 1/4 mile: yet to run (previous best was 12.7 on twins) my car is still under construction https://www.nopistons.com/forums/pub...IR#>/smile.png |
Generation: 2nd
Turbo:Majestic Stage II upgrade, clipped wheel, ported wastegate A/R Unknown PSI: 6 Porting: stock Power: Roughly 275 at flywheel 1/4 mi.: 14.12 @ 96.7 MPH Yep, I'm slow https://www.nopistons.com/forums/pub...#>/biggrin.png |
there's gotta be more turbo cars hiding in the shadows....
|
Generation: 2nd
Turbo: Greddy T78 AR Exhaust: ?? Ported: mild street port Boost: 15-20 psi rwhp: yet to dyno 1/4 mile: yet to run |
3rd genn.
SR Motorsports KKK (stage 2) Street Ported Motor 11.22@121mph...https://www.nopistons.com/forums/pub...IR#>/devil.gif |
You'll get lots of dyno and other stats when my car is done in 3 weeks, Dave says 340-360RWHP stock twins at 15psi. Ken "94 PEP, White, Red Leather www.nopistons.com |
You'll get lots of dyno and other stats when my car is done in 3 weeks, Dave says 340-360RWHP stock twins at 15psi. Ken "94 PEP, White, Red Leather www.nopistons.com |
You'll get lots of dyno and other stats when my car is done in 3 weeks, Dave says 340-360RWHP stock twins at 15psi. Ken "94 PEP, White, Red Leather www.nopistons.com |
You'll get lots of dyno and other stats when my car is done in 3 weeks, Dave says 340-360RWHP stock twins at 15psi. Ken "94 PEP, White, Red Leather www.nopistons.com |
You'll get lots of dyno and other stats when my car is done in 3 weeks, Dave says 340-360RWHP stock twins at 15psi. Ken "94 PEP, White, Red Leather www.nopistons.com |
Generation: 1st
Engine: Cosmo 13B Turbo: Garrett T72 A/R: 1.22 Port: They are big standard, just a clean up. Boost: Street 15psi 98RON fuel. Track 22psi on VP C16. Power: Street = 410 +/-rwhp. Track = 510 +/-rwhp ET: 11.1 @ 125 |
Generation: 2nd
Engine: 13b Turbo Turbo: Upgraded compressor, GN-T3 A/R: Stock, 1.00 or .96 Port: Standard. Boost: Starts at 10psi, drops to 8psi Power: est 241 rwhp ET: 13.7 @ 99.9 with no traction what so ever off the line. |
??? Hopefully this spring /summer I'm have the HKS t04e set-up a nice big FMI not sure which one. And, if all goes well and I have any $$ left I'm thinking of have JR's rotary do a street port if the engien is still in good shape. I had it compression tested at around 90 psi on the back rotor and around 95 on the front rotor so I think I'm in good shape ???
|
I know of a place that jost got a dyno and I want to do a before and after on the car
|
93 RX7
T88. 8 psi. 87 octane. |
91 fc3s
bridgeported HKS t04R a/r 1.15 FCON V PRO ecu 10.6 best 1/4 520 rwhp on pump gas at 20 psi |
93 RX7 T88. 8 psi. 87 octane. |
8 psi? got a big turbo to be pushing all that boost! what kind of ems ya using to control that much boost? :tounge:
|
Ken
'94 white, base, pep, red leather, mods: Hayes street port & polished stage II, 3mm seals, XS-Engineering T04e single turbo kit, Aquamist 2s water injection kit, Pettit ss resonated mid-pipe, Pettit ss cat-back, RP Racing fuel pump, 1200cc injectors, Profec B(10&15psi), Centerforce clutch, under pulley kit(no air pump), Pettit short shifter kit, boost gauge, PFS PMC (10-psi, 15psi), LaBreck's bushings www.nopistons.com Motor needs to be rebuilt, I'm in no rush. 10 inches of snow here in MN. |
8 psi? got a big turbo to be pushing all that boost! what kind of ems ya using to control that much boost? :tounge: I'm a balls to the walls kinda guy https://www.nopistons.com/forums/pub...DIR#>/wink.png |
8 psi? got a big turbo to be pushing all that boost! what kind of ems ya using to control that much boost? :tounge: I'm a balls to the walls kinda guy https://www.nopistons.com/forums/pub...DIR#>/wink.png |
8 psi? got a big turbo to be pushing all that boost! what kind of ems ya using to control that much boost? :tounge: I'm a balls to the walls kinda guy https://www.nopistons.com/forums/pub...DIR#>/wink.png |
mullet head,yeah no ****.
|
8 psi? got a big turbo to be pushing all that boost! what kind of ems ya using to control that much boost? :tounge: I'm a balls to the walls kinda guy https://www.nopistons.com/forums/pub...DIR#>/wink.png |
All times are GMT -5. The time now is 10:32 PM. |
© 2024 MH Sub I, LLC dba Internet Brands