Well , finally got it up and R&R everything. You name it from all the T braces, race clutch,manifold,big fuel, GT40,exhaust , tranny,Kaaz,Power FC and everthing in between. We wanna do it it a little suttle...so everything with engine is satin black except the Intake system and I.C...that is powder coat crimson red.

i guess Ill call it the "Black Widow" with its bight red inside lines.

Leaky trans seal fucked my Centerforce,this is what the turbo looked like.....guess? this POS still ran low 12.s

Ito motor is ready to go. Post up stuff later.

ito monsta

what the fuuuuuu

Ouch.

looks like that turbo swallowed a few nuts

https://www.nopistons.com/forums/pub...#>/biggrin.png https://www.nopistons.com/forums/pub...#>/biggrin.png

Actually I know it was not have a big enough BOV. Its still has little end play but the frequent backpressure finally caught up and the surge bent it into the housing.

How much boost are we talking about here?

Significantly over 15psi?





-Ted

Okay the car was running with those bent turbine fins? https://www.nopistons.com/forums/pub...DIR#>/ohmy.png

It happens when there is too much shaft play, the fins grab hold of the housing.

Why are the exhaust ports covered but not the intake?? Are we hiding something? https://www.nopistons.com/forums/pub...#>/biggrin.png

At the diesel shop if you have a bent fin the compressor will explode from spinning at such high RPMs until full boost and the balance of it being off.. These must not spin at as much RPM though.. https://www.nopistons.com/forums/pub...IR#>/dunno.gif

[/QU looks like that turbo swallowed a few nuts OTE]

like u martin!

Ok so the SSQ I had installed was the universal one that had a ****** hose fitting that was the diameter of you thumb. It wasn't even straight. So with 14.5 lbs over two years it hit one day....and did I know it! sounded like fingernails on a blackboard.

But hey it still ran and I kept going. Now, it doesn't seem to have much end play so thats why it still runs with out continuing to damage.

Oh, and the exhaust ports I said **** it cuase its nothing but big and here is the intake close up.

Awesome ports https://www.nopistons.com/forums/pub...IR#>/bigok.gif

Art - Dr. Freddie sez "these connectors from your wiring harness about to be 'repaired' w/ a razor blade. Say adios to the emissions ****, say buenos dias to mo' power".

another view of the connector blocks that are goin' south.

All the manifold is in. Its ported to match Ito's port.I powder coated all the U.I.M and I.C. and I.C. water tank candy apple...even though it may not look like it in the pic.I ceramic coated the L.I.M. with I high heat barrier ceramic so it doesnt come in red but it will be hidden behind the turbo and piping any way. The water pump, altenator and accesseries are in flat black against the new black bay.

It may work it may not .......

I.C. and U.I.M elbow.