NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   Single Turbo Discussion (https://www.nopistons.com/single-turbo-discussion-13/)
-   -   GT35R (https://www.nopistons.com/single-turbo-discussion-13/gt35r-66608/)

FB MAZDATURBO 07-11-2007 02:20 AM

What I have, this will be a street car. REW street ported by built by Pineapple Racing, 3mm apex seals, oil passage mods, and i am not exactly sure what else, didnt get the motor built. I am looking for 400 horse on 91 octane, And 500ish on C-16. Will a 35r with a .83 P-trim in a T-4 housing get me there? If not what will? I Have done a little bit of research and not been able to really find and answer, I know this question has to get asked all the time too, sorry, just would like to know.

jwteknix 07-11-2007 10:33 AM

i dont think ull make 500

FB MAZDATURBO 07-11-2007 03:47 PM

That would be ok, i dont need a 500 horse race gas tune, just want to drive the car at 500 for shits and giggles. I really am looking for the 400 on pump. The 35r is capable of about 620 flywheel correct. (On a piston engine at least)

j9fd3s 07-12-2007 09:31 AM

most people seem to do about 400-420ish on pump with a gt35r, its a good street turbo because its responsive, if you want to make the big hp#, run the gt40 or something bigger

wackaloo13 07-14-2007 04:36 PM

you could look at an aspec 500r. it is a gt35rs i believe. also, you could run a turbo at high boost and use some water injection for some det protection.

diabolical1 07-26-2007 05:01 AM

GT40R

jwteknix 07-26-2007 06:03 AM

^^^thats the next turbo im getting along with a half bridge


All times are GMT -5. The time now is 11:54 PM.


© 2024 MH Sub I, LLC dba Internet Brands