Found a kit i liked but the turbos a 20G and that seems a bit large, lotsa lag and only top end i suppose but im not sure any input

thanks

20g not that big for a rotary..they are a good size for a dsm..(friend has on on his dsm) They pull pretty good he gets full spool about 4500-5K rpm or so. A 20G is pretty good turbo for the street.

alright thanks man, i dont know to much about turbos. Thanks for the help. any other input would be nice, also what would be a good intercooler for that im lookin at a 2 row from greddy, think id be better off with a 3 row.

How much boost is your friend running in his dsm to hit full by 5k. What kinda dsm i love em tryin to get my buddy to sell his mustang and get another 1gb talon

Hes running 18-20 psi low boost pump gas for that...we have done a few 25psi pulls (100 oct) with that current set up. Hes got a 95 tsi...he keeps breaking x-missions. His J Shep. stage 4 should be in next week.

Gettin a shep trans, those are mint 5 or 6 speed? https://www.nopistons.com/forums/pub...1047683621.gif



What do you think about the intercooler though 2 row be enough or should i go with a 3 row?

what kind of car is this for? DSM or RX-7? and what are your goals?

and hes getting the 5 sp.

an rx 88TII lookin for around 300-350 hp

ok then...use something other than a 20g. like T04E...The Greddy 2 row will be good for that. Dont forget to get all the other supporting mods..fuel etc...

So a 20G would be to big?

Can you think of any company that sells like a full kit with all piping and that good stuff(all but IC).

No..but you could get a better turbo. Greddy does make a 20g kit but you already knew that..not saying don't get it but if you do get a BB turbo. You will have fun with it.

What are the advantages of a bb turbo and whats the greddy turbo?

Would you have some suggestions for a turbo and/or setup that would be good for around 300-350 hp.

thanks

You get a faster spool from a BB turbo..I believe the greddy kits come with a traditional staft type turbo... The 20G will give you the power you want. Another one you could think about its a 60-1 BB turbo..that will give you the numbers you want and spools quicker..

I will say this the kit your looking at I considered too when I started my project its not a bad kit by any means and pretty affordable. I would call and ask if you could get the 20g in BB.. you can always upgrade later.

Alright man thanks for the help again.

I'm sure i'll have more questions in the somewhat near future. So don't be surprised.

Last thing can you make a turbo a BB or does it pretty much have to be made that way and who makes some good 60-1 BB that i could look into.

20g is a small turbo for a rotary.



Go with a GT30R and a HKS manifold. I like larger intercoolers and would like around a 3row 24x18x3in or so or bigger depending on car but around there

Thanks man

I'll look into it

The RX7 "20g" is a 16cm2, the EVO-DSM "20g" is an smaller 8cm2. Cmon, do some research.



The FCs Greddy kit is a quick spooling.

thanks

they have those numbers right on the site but none of it really means anything to me, i dont know that much about turbos...