here it goes my story. i have gotten my hands on a genuine 12at from japan unfortunatly i wan't able to find a wiring harness or ecu to runthe fuel injectors(thats right folks at 12a with fuel injection.. stock. 2x800cc injectors) so i have purchased and somewhat installed a haltech f10 fuel management system. although the engine hasn't run in a while which may be a concern for you rotary enthusiest i have been keepin up with turning the engine with oil in it to keep the seals as fresh as possible. the car that its in is an 84 rx-7 GSL so horay for the lsd rear end which you will need once you get this thing up to speed. i have many other goodies for this thing also. just to list a few. turboxs BOV, NOS fuel pump, 3rd gen intercooler, 3rd gen radiator, momo steerring wheel, manual boost controller, tweed interior. the car was being fitted to be a street monster and a close to full bred race car. i know everyone is weary of pickin up in a project i know i was and the only reason i'm giving up such i rare engine is a lack of money i'm in college wouldn't you know. i paid 2000 for the car and engine, 800 for the haltech and about 800 in other stuff. so my estimate is 3600 invested. now i realize in any car project when sold there is a loss to be had. i am askin 3000. that way the car and haltech are paid for at least the rest is your free. my email is integrrac@yahoo.com or aim= integrrac also so hit me up with any questions thanks for your time.

where are you located?

pittsburgh

*bump*



also lookin for a street bike so i'm open to any interesting trades.

bump*

also if anyone is interested in just parts of this car i have a ton of goodies. turboxs BOV and boost controler, 3rd gen intercooler, 3rd gen radiator, haltech f10, and muc much more haha.

What need to be done to finish the car?

installation of an oil cooler, radiator (both of which come with the car), finish installation of the haltech f10 (includes wiring and a purchase of a gm 2bar map sensor 50$, and drillin a hole for the air inlet temp sensor),fix starter (just needs a puch button installed to fix problem) that is about all that it needs to run really.



once running.



installation of an intercooler (comes with), tuning, paint, 2nd gen turbo(does not come with), 2nd set of injectors, boost controller (comes with), many other good plans set in motion)

12A turbo.. I don't see many of those..

ba ba bump. if anyone is interested i would be willin to sell any components of the car seprately like the engine, haltech, 3rd gen radiator, 3rd gen intercooler, turboxs BOV, boost controller, NOS fuel pump, momo steering wheel with adaptor for 1st gen 7, salt n pepper interior peices, much much more. !!!