I have an 88 na rebuilt and streetported by rotaryresurrection, the engine still has less than 500 miles on the rebuild along with all the new parts I have put on it.
car is a 2 seater red with gray interior, no cruise control (base model). car has very little rust , only on the bubbles on the sunroof and above the windshield , the only real rust is on a small inner spot on one of the back wheelwells and about the length/size of my smallest finger Im just seeing what kind of offers I can get for the car. I dont know if I really want to sell it , but if I did the primary reason would be to hold on to the money so I can buy a clean turbo rx7. Heres a list of whats been done to the car so far. All of the parts/mods , have less than 500 miles on them and are basically like new. - rebuilt streetported engine by rotary resurrection, has less than 500 miles on it - centerforce dual friction clutch, racingbeat lightweight flywheel (7lbs lighter than stock), centerforce throwout bearing - Racing beat header/collector, straight pipe in place of cat, borla dual catback exhaust - kn intake, all new motor and tranny mounts (competition mazda ones, harder rubber), new oil cooler mounts - new waterpump, all new belts, new fuel filter, fuel lines, vacuum hoses, cleaned and flow tested injectors, - all new brake pads and rotors, i did a 5 lug conversion -all new shifter bushings, tranny/diff flushed and have redline fluids (diff is non-lsd) - autometer mechanical water temp gauge works great - removed 5/6 ports, removed all emissions (egr valve airpump, emissions rack), removed bac, removed a/c and power steering, removed interior,have all block off plates on there, tb mod and ported tb, i kept the stock omp - magnacore 8.5mm spark plug wires im not sure if theres anything else i forgot. __________________________________________________ ____ Now what needs attention, Im being completely honest because I know other people arent. Ive been working on this car for two years and believe me it was a mess when i got it. - minor front end damage from 15mph, so hood doesnt line up on one side but still shuts , needs bumper to be pulled out on the front passenger side. - steering has some play to it, maybe tie rod ends or something needs to be tightened -clutch slave may need replacement, seems like it should shift better than it does at times - starter is going and needs to be replaced, unless it can be fixed (sometimes works sometimes doesnt) only like 70 dollars from autoparts store - heat doesnt work, i rerouted the coolant hoses to bypass the heater core - all the gauges/lights on dash, turn on inside the car when i hit the brakes, and the front markers turn on too - needs camber/toe alignment on rear driver side, been like that since i bought it, and also one side in the back seems like its lower than the other - windshield wipers dont stop at the right spot when u shut them off so u have to time it just right im firm with $2500 , here are some pics and a video link of me going to 3500 rpm , car is located in Providence RI. I know it sounds like alot of work and problems , but if i may just keep the car. Ive put over 150+ hours of work into this thing and about $5000 total in parts with the price of the car iself, so its well worth the price im asking. http://i82.photobucket.com/albums/j...hamp/rx7bay.jpg these are both the same video, just incase one doesnt work use the other link http://www.youtube.com/watch?v=XxVQpZYUWWc http://s82.photobucket.com/albums/j...nt=DSCF0071.flv heres another small video http://s82.photobucket.com/albums/j...nt=DSCF0070.flv unfortunately i dont have any other pics of the car and im living in georgia while the car is stored in RI, so i cant take any, but if u look closely on the video and pause it you can see the damage to the hood/front bumper where it isnt lining up. I also have another hood that is unpainted that i can give with the car. |
i will also consider trades for a TII
|
lowering price to $2300 obo
heres link to pics/videos since last ones didnt go in correctly , same video here, just two links http://s82.photobucket.com/albums/j246/fc3...nt=DSCF0071.flv http://www.youtube.com/watch?v=XxVQpZYUWWc another small video - http://s82.photobucket.com/albums/j246/fc3...nt=DSCF0070.flv engine bay pic- http://i82.photobucket.com/albums/j246/fc3...hamp/rx7bay.jpg |
lowering price to $2000
|
Im just going to keep the car, I'll never get what its worth selling it for even $2500 is like selling my soul, Ive put $2500 in just hard labor working on this car
|
All times are GMT -5. The time now is 09:37 PM. |
© 2024 MH Sub I, LLC dba Internet Brands