I have a 1993 Mazda RX7 20b that needs to be completed. I bought the car with a blown 13b motor. The body is straight, the black paint is in good condition and the interior is very nice. I bought a JDM 3 rotor engine that has never been fired up it has one low pulse. It might be a corner seal that hung up so I was going to test run it first. The engine cradle has been fabricated along with a trick new oil pan so as not to change the suspension geometry. The motor can just drop right in.....motor mounts and again EVERYTHING else has been done. The car has Tien coil overs too and nice ASA 18" rims. I have the stainless steel exhaust manifold, new turbo, JGS wategate and blow off valve (both billet not cast) A Wolf computer, ACT clutch and pressure plate. Nice exhaust system and intercooler. I have new fuel injectors and a complete Aeromotive fuel system that will flow all the gas you need. Everything needed to complete the car except time and desire. I do not think you would have to spend a dime on this project to get it up and running.....EVERYTHING has been purchased to have it completed. I have lost interest in the car and would rather have my money now. If you were to purchase all the items above you would spend over 20 grand. Every part for this car and all the fabrication is top professional quality. I am willing to sell this car for a moderate loss. I am not giving it away. If you want to save some money on a badass 3 rotor Rx7 this is your chance. Please no BS or dreamers, CASH buyers only. Thanks. $15,000

any pictures of it?

Just these two lousy photos where it is jammed into the back corner of the shop.