GeneralWiggin

My two main priorities right now are my rebuild of a spare motor I picked up so I can swap before too long and doors.



--I need black doors, driver's side is the most important. I can use all the accessories and glass from my old doors, but the doors need to be the stock Brilliant Black with no chips, few minor dents at most, no rust, and preferably with S4 trim. $100? $150 shipped? I'm willing to hold out for a good deal and I'll drive a state away if the price is right.



--For my rebuild, I'm looking for ALL engine seals and gaskets, and I want FD corner seal springs. I'd prefer new two-piece steel apex seals instead of three piece in the hopes that they wouldn't groove the housings so badly over time, but I will go for a good deal on either. For all these seals I want new, but certain things are more acceptable used than others and it also depends on the price you offer. A brief, but not exhaustive, list: apex seals/springs, side seals/springs, corner seals/FD springs, oil control rings/springs, soft seals, all o-rings... If you have all these seals, springs, and rings I need to rebuild my engine, NEW, then I'll shell out $300 or more. Maybe lots more. I haven't looked real deep into how much it's worth, and I know $300 is low for all that new, I'm just trying to start somewhere.



--I'm also interested in rotor bearings. I know mazdatrix sells them for about $23 a pop so I might just buy those from them. Let me know if you can beat that on new rotor bearings.



OTHER WTB items in rough order of importance:

-gray or black long dash vents so I can mount my VIN plate

-piece of plastic that I can cut to fit around my stereo and make gauge holes later

-driver's side door triangle

-clutch master and slave cylinders

-brake master cylinder w/ reservoir

-passenger FTP lens, must have no cracks anywhere or chips on lens for consideration

-pass side A pillar plastic

-gray rear seats

-one plastic cover for hatch glass lifter struts



My RX-7 is an '87 TII with Rtek 1.7ECU (with 720cc secondaries), a ported wastegate, and an exhaust I built. I have pulled emissions, OMP, and the air pump once the cats were gone. If you think you have something I might want, put it up and I'll let you know, however my cash is extremely prioritized right now, you would have better luck trading me if you're selling something I haven't listed here, there's a huge parts thread I just made.



I do paypal and my zip code is 50014 for figuring shipping.



I am open to trades, see my sale thread:

https://www.nopistons.com/forums/index.php?...t=0#entry889620

NMJ87T2

I have the clutch master and slave cylinders for $45 shipped.

GeneralWiggin

$45 for both? Are they new?

NMJ87T2

No, they are used with about 20k on them.

GeneralWiggin

Ok, the rebuild is becoming very urgent, my budget has increased significantly for this because I need it badly. My motor is getting harder and harder to start due to slow starting speeds coupled with low compression (~85psi all around). I'm absolutely sick of it and it could cost me my job if I don't get it running reliably soon. I have some used apex seals I will spec out and probably use in my spare motor so I can take out the current one and have it rebuilt properly, but I really need FD corner seal springs w/ corner seals and those corner seal soft inserts, the coolant seals, and other gaskets. If you've ever rebuilt a motor you may know what I need: basically every seal that isn't metal. Thanks guys.

GeneralWiggin

C'mon guys

mazmike

ive got an oe mazda t2 gasket set say 100+ship? threr like 275bucks on mazda trix

GeneralWiggin

Could you give me the part number so I can look up what comes in the set? Thank you