9BASE3 |
06-30-2005 08:23 AM |
This particular one replaces the entire main pulley assembly, where the pettit just replaces the outer part.
DO NOT BUY if you don't know how to install this pulley. It is not just a simple bolt on installation. If the engine is in the car, you must use a 2X4 or something to push the flywheel forward so the bearings do not fall out. If you're building a new motor, install just as you would normally...
This is a BAD ASS pulley, and is very worth it - just be sure to have it installed professionally, at a RX7 specific shop.
Only about 50 miles of use.
175.00 SHIPPED.
I'll dig up some pics...
Justin
|